Back · Isometric

Front Lever

The front lever is an advanced calisthenics hold where you hang from a bar with straight arms and hold your body horizontal, face up, parallel to the floor. It builds extreme strength in the lats and core and is usually learned through tuck, advanced tuck and straddle progressions over many months.

Also known as: Front lever hold, Straight-arm lever, FL hold

Muscle group
Back
Movement pattern
Isometric
Type
Compound
Equipment
Pull-up bar
Difficulty
Advanced

What muscles does the front lever work?

Primary movers

  • Latissimus dorsi
  • Rectus abdominis

Assisting muscles

  • Teres major
  • Posterior deltoid
  • Rhomboids
  • Obliques
  • Biceps brachii

The lats are the prime movers, pressing the bar down and back with straight arms to keep your body from dropping. The tension is isometric, so you hold a long contraction rather than moving through a range.

The abs, obliques and glutes hold the body in a straight horizontal line. Any sag at the hips shows up immediately.

The rear delts, teres major, rhomboids and lower traps keep the shoulder blades depressed and pulled back. The biceps and forearms handle the grip.

The skill is hard on the elbows and shoulders. Progress slowly through the tuck variations and stop if you feel joint pain.

How to do the front lever

Setup

  1. 1

    Hang from a bar with an overhand grip about shoulder-width apart, arms straight.

  2. 2

    Pull your shoulder blades down and squeeze your lats.

  3. 3

    Start with a tuck front lever before attempting the full version.

  4. 4

    Warm up the shoulders, elbows and wrists.

Execution

  1. 1

    Keep your arms straight and raise your body until it is horizontal and face up.

  2. 2

    Hold a straight line from your shoulders to your feet.

  3. 3

    Squeeze your glutes and point your toes.

  4. 4

    Push down on the bar through your lats.

  5. 5

    Lower your legs back down under control to finish.

Common front lever mistakes

Bending the elbows

It turns the hold into a row and removes the straight-arm demand.

The fix: Keep your arms locked and push the bar down.

Letting the hips drop

The body falls below horizontal and the lever is easier but incorrect.

The fix: Squeeze your glutes and brace your abs.

Arching the lower back

It can strain the spine and hides weak core control.

The fix: Posteriorly tilt your pelvis and keep your ribs down.

Skipping the progressions

The load on the elbows and shoulders is too high too soon.

The fix: Work through tuck progressions first.

How many sets and reps?

GoalSetsRepsLoadRest
Skill practice4–65–15 sTuck or advanced tuck90 s–2 min
Strength3–58–20 sAdvanced tuck or straddle2 min
Beginner310–20 sTuck holds and inverted rows90 s

Use short holds with long rests and stop each set before your form breaks. Support the skill with pull-ups, rows and core work.

Running the front lever in your next block? Hercules logs every set, shows last session's numbers before you lift, and suggests when to add weight.

Get it on Google Play

Front Lever variations and alternatives

Dead Hang

Easier

Builds the grip and shoulder base.

A horizontal pull that builds back strength.

Pull-ups

Alternative

A vertical pull that builds the lats.

Hollow Body Hold

Alternative

Teaches the body-line tension needed for the lever.

A dynamic pulling skill that also needs strong lats.

Frequently asked questions

How long does it take to learn the front lever?

Many months to over a year, depending on your starting strength.

What muscles does the front lever work?

The lats and core mainly, plus the rear delts, rhomboids and glutes.

What is a tuck front lever?

The same hold with your knees pulled to your chest, which shortens the lever.

Is the front lever bad for your elbows?

It loads the elbows and shoulders heavily. Build up slowly and avoid pain.

Hercules tracks every front lever you log, shows you last session's numbers before you lift, and flags when your progress stalls.

Get it on Google Play