Core · Spinal flexion

Band Leg Raises

The band leg raise is a core exercise where you lie on your back with a resistance band looped around your ankles and anchored low, then raise your straight legs toward the ceiling against the pull. The band adds resistance to a plain leg raise, so it targets the lower abs and hip flexors harder.

Also known as: Resistance band leg raise, Banded lying leg raise, Band-resisted leg raise

Muscle group
Core
Movement pattern
Spinal flexion
Type
Isolation
Equipment
Resistance band, Anchor point, Exercise mat
Difficulty
Intermediate

What muscles does the band leg raises work?

Primary movers

  • Rectus abdominis
  • Hip flexors

Assisting muscles

  • Obliques
  • Quadriceps
  • Erector spinae

The lower part of the rectus abdominis and the hip flexors do most of the work. The abs keep your pelvis tilted and your lower back flat, while the hip flexors swing the legs up.

The obliques help keep your legs from drifting to one side, and the quadriceps keep your knees straight against the pull of the band.

The band is the difference from a regular leg raise. Its tension is lightest when your legs are low and grows as they rise, so the top of the rep feels hardest.

Because the band pulls your legs away from the lift, your abs also have to control the lowering phase, which is where your lower back is most likely to lift off the floor.

How to do the band leg raises

Setup

  1. 1

    Loop a resistance band around a low, sturdy anchor point and lie on an exercise mat far enough away that the band is taut.

  2. 2

    Place the other end of the band around both ankles.

  3. 3

    Lie flat with your legs straight and put your hands behind your head or under your hips.

  4. 4

    Brace your abs and press your lower back into the floor before the first rep.

Execution

  1. 1

    Keeping your legs straight and together, raise them until your feet point at the ceiling.

  2. 2

    Pause briefly at the top while keeping your lower back flat.

  3. 3

    Lower your legs slowly toward the floor against the band's pull.

  4. 4

    Stop just above the floor and keep your back down.

  5. 5

    Repeat for the desired number of repetitions.

Common band leg raises mistakes

Arching the lower back

As your legs lower, the band pulls and your back lifts off the floor.

The fix: Stop the rep higher, press your back into the mat, and shorten the range until you can keep it flat.

Bending the knees

Bent knees shorten the lever and make the lift easier than intended.

The fix: Keep your legs straight, or bend slightly only if your hamstrings are tight.

Swinging with momentum

Kicking the legs up skips the abs and loads the lower back.

The fix: Lift smoothly and take about two seconds to lower.

Letting the band drag your legs down

Dropping fast removes the control that builds strength.

The fix: Resist the band on the way down and use a lighter band if you cannot.

How many sets and reps?

GoalSetsRepsLoadRest
Hypertrophy3–410–15Medium band, slow lowering60 s
Endurance2–315–20Light band45 s
Beginner2–38–10Light band, shorter range60 s

Place it after heavier core or leg work, or on its own as an ab finisher. Use a lighter band or move closer to the anchor until you can keep your back flat for every rep.

Running the band leg raises in your next block? Hercules logs every set, shows last session's numbers before you lift, and suggests when to add weight.

Get it on Google Play

Band Leg Raises variations and alternatives

Same movement with only body weight and no band.

You hang from a bar, so grip and body control add to the challenge.

Band Tuck-ups

Alternative

A band-resisted version that bends the knees toward the chest.

Frequently asked questions

What do band leg raises work?

The lower abs and hip flexors, with help from the obliques and quads.

How is it different from a regular leg raise?

The band adds resistance that is highest at the top, so the lift is harder and the lowering needs more control.

Where should I anchor the band?

Use a low, solid anchor and set your distance so the band is taut at the bottom.

Why does my lower back lift off the floor?

Your abs are not controlling the lowering. Stop higher, use a lighter band, or move closer to the anchor.

Hercules tracks every band leg raises you log, shows you last session's numbers before you lift, and flags when your progress stalls.

Get it on Google Play