Back · Horizontal pull
Cable Chest Supported Row
The cable chest supported row is a row done lying face down on an incline bench that faces a low pulley. The pad holds your chest, so your lower back rests and you cannot swing. You pull the handle toward your stomach and squeeze your shoulder blades together. It trains the lats and middle back with steady cable tension.
Also known as: Chest supported cable row, Incline bench cable row, Prone cable row
- Muscle group
- Back
- Movement pattern
- Horizontal pull
- Type
- Compound
- Equipment
- Cable machine, Incline bench, Single handle or straight bar
- Difficulty
- Beginner
What muscles does the cable chest supported row work?
Primary movers
- Latissimus dorsi
- Rhomboids
- Middle trapezius
Assisting muscles
- Rear deltoid
- Biceps brachii
- Lower trapezius
The lats pull your upper arms back toward your sides.
The rhomboids and middle traps pull your shoulder blades together.
The rear delts and biceps help with the pull.
The bench takes the place of your lower back muscles. This lets you focus on the upper back and stop when it is tired, not when your posture fails.
How to do the cable chest supported row
Setup
- 1
Place an incline bench at about 45 degrees with its head end facing a low pulley.
- 2
Attach a bar or two handles to the cable.
- 3
Lie face down with your chest on the pad and your feet on the floor.
- 4
Hold the handle with your arms extended and the cable tight.
Execution
- 1
Pull your shoulder blades back.
- 2
Drive your elbows back along your sides.
- 3
Bring the handle toward your stomach.
- 4
Pause and squeeze your shoulder blades together.
- 5
Return slowly until your arms are straight.
Common cable chest supported row mistakes
Lifting the chest off the pad
The lower back joins in and you lose the point of the exercise.
The fix: Keep your chest in contact for the whole rep.
Shrugging
The upper traps take over.
The fix: Keep your shoulders down and back.
Pulling with the arms only
The biceps tire and the back does little.
The fix: Start each rep by moving the shoulder blades.
Letting the weight jerk your arms forward
The shoulders are pulled around without control.
The fix: Lower over two to three seconds.
How many sets and reps?
| Goal | Sets | Reps | Load | Rest |
|---|---|---|---|---|
| Hypertrophy | 3–4 | 10–12 | Moderate | 60–90 s |
| Strength | 3–4 | 6–8 | Heavy | 2 min |
| Beginner | 2–3 | 10–12 | Light | 60 s |
Use it when your lower back is tired from deadlifts or squats. Move the bench back until the weight stack does not touch down at full reach.
Running the cable chest supported row in your next block? Hercules logs every set, shows last session's numbers before you lift, and suggests when to add weight.
Get it on Google PlayCable Chest Supported Row variations and alternatives
Dumbbell Chest Supported Row
AlternativeDumbbells on the same bench, with no cable needed.
Seated Cable Rows
AlternativeSeated, with your lower back holding you upright.
A machine that allows heavier loading.
Frequently asked questions
What does the cable chest supported row work?
It mainly works the lats, rhomboids and middle traps, with the rear delts and biceps helping.
Why support the chest?
It takes the lower back out and stops you from swinging the weight.
What bench angle should I use?
About 45 degrees. Lower angles work too if the cable still lines up with your pull.
Which handle is best?
A straight bar, a V-handle or two single handles all work. Choose the one that feels best for your shoulders.
Is it good for people with lower back pain?
It is often more comfortable than bent-over rows. Check with a professional if you have an injury.
Hercules tracks every cable chest supported row you log, shows you last session's numbers before you lift, and flags when your progress stalls.
Get it on Google Play