Back · Vertical pull
Front Lever Raises
Front lever raises are an advanced bodyweight pull where you hang from a bar or rings, lift into an inverted hang and then lower your body with straight arms until it is horizontal. They build the lat, core and shoulder strength needed to hold a full front lever and need strong straight-arm control.
Also known as: Front lever negatives raises, Inverted hang to front lever, Straight-arm lever raise
- Muscle group
- Back
- Movement pattern
- Vertical pull
- Type
- Compound
- Equipment
- Pull-up bar
- Difficulty
- Advanced
What muscles does the front lever raises work?
Primary movers
- Latissimus dorsi
- Rectus abdominis
Assisting muscles
- Teres major
- Posterior deltoid
- Obliques
- Lower trapezius
- Forearm flexors
The latissimus dorsi are the main muscles. They pull your arms down toward your hips, and in this exercise they fight to keep your body from dropping toward the floor. The longer your body is from the bar, the harder they work.
The abs, especially the rectus abdominis, hold your trunk straight against that leverage. If the hips pike or sag, the lever shortens or the lower back takes over, so the abs work isometrically through the whole range.
The teres major and posterior deltoid help the lats pull your arms down, and the lower trapezius keeps your shoulder blades down. The forearms grip the bar for the whole set, and the obliques help prevent twisting.
Unlike a pull-up, your elbows stay straight, which gives the movement its demanding leverage. This is why tucked versions are a good starting point, and why the lowering phase builds so much strength.
How to do the front lever raises
Setup
- 1
Hang from a bar or rings with an overhand grip, hands about shoulder-width apart.
- 2
Pull your body up into an inverted hang, with your hips above your head and your legs pointing up.
- 3
Keep your arms straight and your shoulders pulled down.
- 4
Tuck your knees at first if you are still building strength.
Execution
- 1
With straight arms, slowly lower your body until it is horizontal, in a front lever.
- 2
Keep your body tight and your legs together.
- 3
Pause briefly at the bottom if you can hold the position.
- 4
Pull back up to the inverted hang by pressing the bar toward your hips.
- 5
Keep your arms straight and move slowly in both directions.
- 6
Repeat for the desired number of repetitions.
Common front lever raises mistakes
Bending the arms
Bent elbows turn the raise into a pull-up and take away the straight-arm strength you are training.
The fix: Lock your elbows straight and lower only as far as you can keep them that way.
Piking at the hips
Bending at the hips shortens the lever, which makes the raise easier but misses the target.
The fix: Squeeze your glutes and abs so your body stays in one line.
Dropping quickly into the bottom
Falling fast loads your shoulders and elbows suddenly and gives you no control.
The fix: Lower over three to five seconds, and stop at a point you can control.
Swinging
Momentum replaces strength and makes it hard to tell if you are making progress.
The fix: Start from a still inverted hang and keep your body rigid.
How many sets and reps?
| Goal | Sets | Reps | Load | Rest |
|---|---|---|---|---|
| Hypertrophy | 3–4 | 3–6 | Tuck or advanced tuck, slow tempo | 2 min |
| Strength | 4–5 | 2–5 | Longer lever, controlled lowering | 2–3 min |
| Beginner | 3–4 | 3–5 | Tucked knees | 90 s–2 min |
Raises build the strength for a full front lever hold. Start with tucked knees and extend your legs as you get stronger, and stop a set when your arms start to bend or your hips pike.
Running the front lever raises in your next block? Hercules logs every set, shows last session's numbers before you lift, and suggests when to add weight.
Get it on Google PlayFront Lever Raises variations and alternatives
Tuck Front Lever Raise
EasierTucking the knees shortens the lever and is the best place to start.
Dead Hang
EasierBuilds the grip and shoulder base that straight-arm work needs.
Ring Rows
AlternativeA horizontal pull that builds the same back muscles with more control.
Hanging Leg Raise
AlternativeTrains the core in a hanging position with a smaller shoulder demand.
Front Lever
HarderHolding the full position is the goal that raises build toward.
Frequently asked questions
What is the difference between front lever raises and a front lever?
A front lever is a static hold in a horizontal position. Raises are the moving version, where you lower into and rise out of that position.
How do I start if I cannot do a front lever?
Begin with tucked knees and a short range. Lower only as far as you can control and build up over several weeks.
What muscles do front lever raises work?
The lats and abs do most of the work, with the shoulders, upper back and forearms helping.
Are they hard on the elbows?
Straight-arm work puts load on the elbows and shoulders, so build up slowly and stop if you feel sharp pain.
Hercules tracks every front lever raises you log, shows you last session's numbers before you lift, and flags when your progress stalls.
Get it on Google Play