Shoulders · Shoulder abduction

Seated Dumbbell Bent Arm Lateral Raise

The seated dumbbell bent arm lateral raise is a shoulder exercise where you sit on a bench and raise two dumbbells out to the sides with your elbows bent. Bending the elbows shortens the lever, so you can use a bit more weight, and sitting stops you from swinging with your legs. It trains the side delts.

Also known as: Seated bent arm dumbbell side raise, Seated bent elbow lateral raise, Seated dumbbell bent arm side raise

Muscle group
Shoulders
Movement pattern
Shoulder abduction
Type
Isolation
Equipment
Dumbbells, Bench
Difficulty
Beginner

What muscles does the seated dumbbell bent arm lateral raise work?

Primary movers

  • Lateral deltoid

Assisting muscles

  • Anterior deltoid
  • Rear deltoid
  • Upper trapezius
  • Forearm flexors

The lateral deltoid, the side of your shoulder, does the lifting. It raises your upper arms away from your sides until they are about level with your shoulders.

The front and rear delts assist, and the upper trapezius works to keep your shoulder blades steady.

Bending your elbows shortens the lever arm of the dumbbell, so the same weight feels lighter than with straight arms. That makes it easier to learn and to use a little more load.

Sitting takes your legs and hips out of the lift. It is a good choice if you tend to rock your body on standing raises.

How to do the seated dumbbell bent arm lateral raise

Setup

  1. 1

    Sit near the end of a bench with your feet flat and your back upright.

  2. 2

    Hold a dumbbell in each hand at your sides with your elbows bent to about 90 degrees.

  3. 3

    Keep your chest up and your shoulders relaxed and down.

Execution

  1. 1

    Raise your arms out to the sides, leading with your elbows.

  2. 2

    Stop when your upper arms are level with your shoulders.

  3. 3

    Pause briefly at the top.

  4. 4

    Lower the dumbbells slowly back to your sides.

  5. 5

    Repeat for the desired number of repetitions.

Common seated dumbbell bent arm lateral raise mistakes

Swinging the torso

Rocking back adds momentum and removes the work from the side delts.

The fix: Sit tall, brace lightly, and use a lighter dumbbell.

Raising above shoulder height

Going higher shifts work to the traps and can irritate the shoulders.

The fix: Stop when your upper arms are level with your shoulders.

Shrugging

The upper traps take over from the side delts.

The fix: Keep your shoulders down and think about lifting your elbows.

Dropping the weights

A quick drop wastes the lowering phase.

The fix: Take two to three seconds to lower the dumbbells.

How many sets and reps?

GoalSetsRepsLoadRest
Hypertrophy3–410–15Light to moderate60 s
Endurance2–315–20Light45 s
Beginner2–310–12Very light60 s

Use it after your heavier pressing as a finisher for the side delts. Small weights work well because the raise is a single-joint movement.

Running the seated dumbbell bent arm lateral raise in your next block? Hercules logs every set, shows last session's numbers before you lift, and suggests when to add weight.

Get it on Google Play

Seated Dumbbell Bent Arm Lateral Raise variations and alternatives

The machine guides the path for you.

The same raise with straighter arms.

Standing with a longer lever and more balance demand.

Frequently asked questions

What does the bent arm lateral raise work?

The side delts, with small help from the front and rear delts and upper traps.

Why bend the elbows?

Bending them shortens the lever, so the movement is easier on your shoulders and elbows.

Why sit down?

Sitting removes leg drive, so the side delts do the work.

How heavy should the dumbbells be?

Light enough that you can lift without swinging and control the way down.

Hercules tracks every seated dumbbell bent arm lateral raise you log, shows you last session's numbers before you lift, and flags when your progress stalls.

Get it on Google Play