Shoulders · Horizontal abduction
Cable Reverse Fly
The cable reverse fly is a shoulder isolation exercise where you cross two cables in front of you and pull your arms out and back until they form a T. It trains the rear deltoids and upper back with constant cable tension. Keep the weight light and the reps slow.
Also known as: Cable rear delt fly, Crossover reverse fly, Standing cable rear delt fly
- Muscle group
- Shoulders
- Movement pattern
- Horizontal abduction
- Type
- Isolation
- Equipment
- Cable machine
- Difficulty
- Beginner
What muscles does the cable reverse fly work?
Primary movers
- Posterior deltoid
Assisting muscles
- Rhomboids
- Middle trapezius
- Infraspinatus
- Teres minor
The posterior deltoid is the main muscle. It pulls your arms out and back from the front of your body, and the crossed cables give it tension from the very first inch of the movement.
The rhomboids and middle trapezius pull your shoulder blades together as your arms open into a T. A short squeeze at the end of the range brings them in, but the lift should still start from the rear delts.
The infraspinatus and teres minor on the back of the shoulder blade help rotate and steady the shoulder as the arms travel back. They make the movement feel controlled instead of wobbly.
Compared with the dumbbell version, the cable keeps constant tension, including in the start position where a dumbbell gives almost none. That makes it easier to feel the rear delts, and it is easier to keep your torso upright while you work.
How to do the cable reverse fly
Setup
- 1
Set both pulleys of a cable crossover to about shoulder height and stand in the middle.
- 2
Cross your arms and grab the left cable with your right hand and the right cable with your left hand.
- 3
Stand tall with your arms straight out in front of you and a slight bend in your elbows.
- 4
Step back slightly so the cables are under light tension.
Execution
- 1
Keep the slight bend in your elbows.
- 2
Pull your arms out and back until they form a T with your body.
- 3
Keep your arms at shoulder height as they open.
- 4
Squeeze your shoulder blades together at the end.
- 5
Let your arms return slowly to the crossed position.
- 6
Repeat for the desired number of reps.
Common cable reverse fly mistakes
Bending the elbows into a row
Pulling the hands to your ribs trains the lats and biceps more than the rear delts.
The fix: Hold the same elbow angle and move your hands out wide.
Leaning back to pull the weight
Leaning gives you momentum and takes tension off the rear delts.
The fix: Stay tall and lower the weight until you can keep your torso still.
Letting the arms drop below shoulder height
A low path shifts work to the lats and cuts the rear delt effort.
The fix: Keep your hands at shoulder height through the whole rep.
Letting the cables yank the arms back
Dropping the weight on the way in gives up the lowering phase and strains the shoulder.
The fix: Control the return for about two seconds.
How many sets and reps?
| Goal | Sets | Reps | Load | Rest |
|---|---|---|---|---|
| Hypertrophy | 3–4 | 12–20 | Light, 1–2 reps in reserve | 45–60 s |
| Strength | 3–4 | 8–12 | Moderate, strict form | 60–90 s |
| Beginner | 2–3 | 10–15 | Very light, slow tempo | 60 s |
Use the cable reverse fly as a shoulder accessory after heavy pressing or pulling. Light weight and slow reps work best, so raise the load only when you can keep your arms at shoulder height and your shoulders down.
Running the cable reverse fly in your next block? Hercules logs every set, shows last session's numbers before you lift, and suggests when to add weight.
Get it on Google PlayCable Reverse Fly variations and alternatives
Rear Delt Machine
EasierA guided path with a supported chest makes it simpler to learn.
Sitting supports your torso while you learn the rear delt movement.
Dumbbell Bent-Over Reverse Fly
AlternativeThe free-weight version, with the hardest point at the top.
Face Pull
AlternativeTrains the rear delts and upper back with a pull toward your face.
Single-Arm Cable Reverse Fly
AlternativeWorks one side at a time, so you can fix any difference between arms.
Frequently asked questions
What does the cable reverse fly work?
It targets the rear deltoids, with help from the muscles between your shoulder blades.
Why cross the cables?
Crossing them puts the cable path in line with the rear delts so tension starts right away instead of at the end of the rep.
How heavy should I go?
Light. The rear delts are small, and heavy weights turn the move into a row.
How is it different from the dumbbell version?
The cable keeps tension on the muscle through the whole range and does not require you to hold a hinged torso position.
Hercules tracks every cable reverse fly you log, shows you last session's numbers before you lift, and flags when your progress stalls.
Get it on Google Play