Back · Horizontal pull

Barbell Seal Row

The barbell seal row is a back exercise where you lie face down on a raised bench and row a barbell up toward the bench from below. Your chest stays on the bench, so your lower back gets a break and you cannot use momentum, which makes it one of the strictest ways to train the lats and mid back.

Also known as: Seal row, Prone barbell row, Chest-supported barbell row

Muscle group
Back
Movement pattern
Horizontal pull
Type
Compound
Equipment
Barbell, Flat bench, Weight plates
Difficulty
Intermediate

What muscles does the barbell seal row work?

Primary movers

  • Latissimus dorsi
  • Trapezius (middle)

Assisting muscles

  • Rhomboids
  • Rear deltoid
  • Biceps brachii
  • Brachialis
  • Forearm flexors

The lats and the middle back, including the middle trapezius and rhomboids, do most of the work. They pull your elbows back and squeeze your shoulder blades together.

The rear deltoid, biceps and brachialis assist, and the forearms hold the bar. Because you lie on the bench, none of these muscles need to hold your torso in position.

This is the main benefit of the seal row. With the chest supported, the lower back and hamstrings are not tired by holding a hinge, so more of your effort goes into the muscles you want to train.

It also removes cheating. You cannot swing your body, so the weight you can lift is the weight your back can truly row.

How to do the barbell seal row

Setup

  1. 1

    Raise a flat bench on blocks or plates so your arms can hang fully without the bar touching the floor.

  2. 2

    Place a loaded barbell on the floor beneath the bench.

  3. 3

    Lie face down on the bench and grab the barbell with an overhand grip, slightly wider than shoulder-width.

  4. 4

    Keep your head in line with your spine.

Execution

  1. 1

    Pull the bar up toward the underside of the bench.

  2. 2

    Drive your elbows back and squeeze your shoulder blades together.

  3. 3

    Pause briefly at the top of the row.

  4. 4

    Lower the bar slowly until your arms are straight.

  5. 5

    Repeat for the desired number of repetitions.

Common barbell seal row mistakes

A bench that is too low

The bar touches the floor and you cannot get a full stretch.

The fix: Raise the bench until your arms hang fully with the bar clear of the floor.

Lifting the chest off the bench

Arching up uses your lower back to help and removes the strictness.

The fix: Keep your chest and stomach on the bench during the whole rep.

Bouncing the bar on the floor

A bounce skips the stretch and can strain the shoulders.

The fix: Lower the bar until your arms are straight, without letting it rest.

Pulling with the biceps

Bending the elbows first uses the arms and not the back.

The fix: Think about driving your elbows toward the ceiling.

How many sets and reps?

GoalSetsRepsLoadRest
Hypertrophy3–48–12Moderate, pause at the top90 s
Strength45–8Heavy, strict form2 min
Beginner2–310–12Light90 s

Use the seal row as a main back exercise, especially if your lower back is tired from squats or deadlifts. Start lighter than your regular bent-over row and add weight as you get used to the setup.

Running the barbell seal row in your next block? Hercules logs every set, shows last session's numbers before you lift, and suggests when to add weight.

Get it on Google Play

Barbell Seal Row variations and alternatives

Dumbbells are easier to set up and lift.

Barbell Seal Row With a Pause

Harder

Hold the top for two seconds to remove all momentum.

The standard row that also trains the lower back.

A machine-based supported row.

Starts each rep from the floor.

Frequently asked questions

What does the barbell seal row work?

The lats and mid back, with help from the rear delts, biceps and forearms.

Why is the seal row so strict?

Your chest is on the bench, so you cannot use momentum from your legs or lower back.

How high should the bench be?

High enough that your arms hang straight and the bar does not touch the floor at the bottom.

Can I use a straight bar?

Yes. A cambered bar lets you pull a little higher, but a straight bar works too.

Hercules tracks every barbell seal row you log, shows you last session's numbers before you lift, and flags when your progress stalls.

Get it on Google Play